General

No epoxy bonds on our plastic mixing tray. The white colour also makes it easier to check our mixing colour control system.

No. The minimum layer thickness for these pastes is 5 mm. For filling, use DRY FLEX® SF.

Yes. The surface of the resin will react with moisture from the air, will not fully harden and must be removed.

When using repair resin, a good adhesion must be created between resin and wood, because the resin is too firm to penetrate the substrate properly.…

Rotating parts such as windows and doors do not necessarily have to be replaced when damaged. As long as the damage is non-constructive (i.e. not…

This is an epoxy without fillers. The addition of (cheap) fillers – such as glass beads or chalk – results in the presence of unbound…

Yes, DRY FLEX® SF is a filler and can be used for natural cracks and small defects (< 6mm) in new and unpainted wood. Any…

The curing of DRY FLEX® and BIO FLEX® is, due to its character (chemical curing), dependent on mass and (environmental) temperature. A larger layer thickness…

Yes, our products are guaranteed for 10 years, subject to conditions.

With the correct preparation and application, DRY FLEX® repairs will last for the lifetime of the substrate. The repairs will also significantly extend redecoration cycles.

The cost of repairs is significantly lower than replacement. The exact cost depends on several factors and our Excel spreadsheet gives a good indication of…